Seventy Degrees Print Bed for Perfect Prints

I've been doing a lot of 3D printing lately. For some reason I've got it into my head that it might be neat to sell little 3D tags as part of the Red Nose Day event. Which means I have to print them. Una, my lovely 3D printer has been misbehaving a bit of late, prints have not been adhering to the print bed very well and their undersides have been a bit rough.

Last night at C4DI I was talking to Robert and he reckoned the way to get perfect prints was to print with no adhesive on the bed and whack the printing bed temperature up to 70 degrees (which is actually rather hot for my tastes).

Anyhoo, I tried it today and it works a treat. The PLA sticks to the clean glass surface and then when everything cools down the prints just pop off the print bed with no problems. And each print has a lovely glassy smooth finish on the bottom.

I'm kind of annoyed that I didn't try this earlier. Why would I have a heated bed on the printer if I didn't actually make it properly warm? Anyhoo, I'm now turning out lovely tags. They'll be on sale next week.